FYS4231 – Sensors and Measurement Technology

Schedule, syllabus and examination date

Choose semester

Changes in the course due to coronavirus

Autumn 2020 we plan for teaching and examinations to be conducted as described in the course description and on semester pages. However, changes may occur due to the corona situation. You will receive notifications about any changes at the semester page and/or in Canvas.

Spring 2020: Teaching and examinations was digitilized. See changes and common guidelines for exams at the MN faculty spring 2020.

Course content

The course introduces all the main kinds of sensors and the physical principles behind different sensing mechanisms. Examples of how to include a sensor in a practical experimental set-up are also given.

Learning outcome

After completing the course:

  • you will be familiar with the main types of sensors
  • you will know the physical principles utilized in the different kinds of sensors
  • you can calculate the transfer function of a simple amplifier system connected to the sensor
  • you will have experience in managing other students in laboratory work

Admission to the course

Students admitted at UiO must apply for courses in Studentweb. Students enrolled in other Master's Degree Programmes can, on application, be admitted to the course if this is cleared by their own study programme.

Nordic citizens and applicants residing in the Nordic countries may apply to take this course as a single course student.

If you are not already enrolled as a student at UiO, please see our information about admission requirements and procedures for international applicants.

Formal prerequisite knowledge

The following courses must be completed before the project work in FYS4231:

It would also be an advantage if you have completed FYS1210 – Elementary Electronics with Project Work.

Overlapping courses

Teaching

The course spans over one full semester with two hours of lectures and two hours of laboratory work each week.

Mandatory laboratory assignments and one project must be completed and approved in order to take the final exam.

Regulations for mandatory assignments can be found here.

As the teaching involves laboratory and/or field work, you should consider taking out a separate travel and personal risk insurance. Read about your insurance cover as a student.

Examination

Mandatory laboratory assignments and one project must be completed and approved in order to take the final exam. 

A final oral or written examination (4hours), which counts 100% towards the final grade. A decision for oral or written exam is based on the number of students who register for the course.

It will also be counted as one of the three attempts to sit the exam for this course, if you sit the exam for one of the following courses: ​FYS3230 – Sensors and measurement technology (continued), FYS3231 – Sensors and Measurement Technology.

Examination support material

No examination support material is allowed.

Language of examination

Subjects taught in English will only offer the exam paper in English.

You may write your examination paper in Norwegian, Swedish, Danish or English.

Grading scale

Grades are awarded on a scale from A to F, where A is the best grade and F is a fail. Read more about the grading system.

Resit an examination

This course offers both postponed and resit of examination. Read more:

Special examination arrangements, use of sources, explanations and appeals

See more about examinations at UiO

Last updated from FS (Common Student System) Aug. 9, 2020 5:11:55 PM

Facts about this course

Credits
10
Level
Master
Teaching
Autumn
Examination
Autumn
Teaching language
Norwegian (English on request)